An easy way to divide our Soft Foam Heart into 8 segments.
You will need...
- The easy-to-use Heart Marking Ruler Strip found below
- Paper scissors
- Pen/Pencil/Marker
- A couple of pins
- Flexible tape measure
You can find our Soft Foam Hearts, right HERE.
Directions:
- Print out the template at 100% (do not re-size or use the 'Shrink to Fit' option on your printer).
- Cut out one of the templates.
- Pin to the mold line down one half of your Soft Foam Heart.
- Use the lines on the template to draw guidelines around the edge of your heart.
Is there any other way you can find the center on the heart on each side? I just destroyed one of my foam hearts. Just can’t seam to mark it correctly.
Hi Frankie, I’m so sorry you are having some trouble marking your heart! This is the most accurate way we have found to find the center. You can try using a narrow ribbon and some pins to mark the lines, rather than a pen so you can readjust them until you are happy with them and that may give you a little bit of wiggle room without putting any permanent marks on your foam.
Will you eventually get hearts with the lines already marked? I don’t know why but I’m not very good at drawing the lines evenly.
Hi Frankie, thanks for reaching out! Right now, we don’t have plans for a pre-marked heart, but I will defineitly share your feedback! If we are able to offer something like that in the future we’ll be sure to send out an email.
PLEASE, PLEASE PLEASE start putting the lines on your hearts. I printed out the strips (yes, to 100%) and my lines are not equal quarters. The strip put the upper lines too high so there is more on the bottom than the top. I followed the video closely too.
Hi Christine, I am so sorry to hear you’re having some trouble with the heart templates! I know working on those awkward shapes can be tricky sometimes. I will defineitly share your feedback about carrying pre-marked hearts with Staci Ann.
I’m so sorry again!